Effect of different catalysts on recovery and reuse of waste polyurethane rigid foam

编号 020028904

推送时间 20210503

研究领域 林产化工 

年份 2021 

类型 期刊 

语种 英语

标题 Effect of different catalysts on recovery and reuse of waste polyurethane rigid foam

来源期刊 Materials Research Express

期 第289期

发表时间 20210326

关键词 waste polyurethane rigid foam;  DMC;  Alcoholysis;  foam; 

摘要 The sharp increase of waste polyurethane rigid foam has caused great harm to the natural environment. Ethylene glycol (EG) and propylene glycol (PG) was the alcoholysis agents, and KOH and Zn-3[Co(CN)(6)](2)(DMC) were used as catalysts for alcoholysis of waste polyurethane rigid foam. Regenerated polyols were prepared. The effects of different catalysts on the infrared, viscosity and hydroxyl content of alcoholysis products were discussed. Regenerated polyurethane rigid foam was prepared from alcoholysis products and analyzed by compression strength, thermal conductivity, water absorption, scanning and thermogravimetry. The effects of different catalysts on the recycling of waste polyurethane rigid foam were studied. The experimental results show that DMC catalyst is more effective than KOH catalyst under the same conditions.The alcoholysis product of DMC system has lower viscosity and higher hydroxyl content, which is more suitable for the preparation of regenerated polyurethane rigid foam., The compressive strength of the prepared regenerated polyurethane rigid foam is 254 Kpa, and the thermal conductivity is 0.0213 W m(-1)K(-1) when the amount of DMC added is 0.04%. Meanwhile, the regenerated polyurethane rigid foam has good hydrophobicity, excellent heat preservation performance, complete cell morphology and good?thermal stability. It can replace the traditional polyols to prepare the regenerated polyurethane material which meets the national standard 'rigid?polyurethane foam?for building insulation' (GB/ T21558-2005).

服务人员 尚玮姣

服务院士 宋湛谦

PDF文件 浏览全文